Description
Water heater breaks and basement seepage dump standing water that demands high-velocity extraction before mold sets in. The Shop-Vac 9627106 12 Gallon 5.5 Peak HP vacuum evacuates standing water fast powered by a high-output 120V motor. Operating noise climbs past 78 dBA under load, causing operator ear fatigue without hearing protection.
High-impact polyethylene constructs the 12 Gallon canister, resisting wall stress cracks from drops and cold garage temperatures. The 5.5 Peak HP single-stage motor pulls high CFM through an aluminum fan impeller, venting exhaust through a rear blower port. An internal float ball rises to seal the motor intake when water reaches capacity, stopping liquid entry into the fan deck. Plastic toggle clamps snap over the tank rim to hold gasket compression under vacuum.
High Velocity Extraction Matrix
Contractors and auto detailers deploy this high-horsepower vacuum for rapid water recovery, vehicle interior cleaning, and yard debris blowing. The top carry handle aids one-hand carrying between service calls.
- 5.5 Peak HP motor generates high airflow velocity for rapid liquid and heavy debris recovery
- 12 Gallon polyethylene tank holds substantial fluid volume for residential flood response
- Rear blower port converts the vacuum into a high-speed workshop blower via hose connection
- Internal float valve shuts off suction when water levels peak to prevent liquid motor intrusion
- Four-caster dolly base rolls across smooth garage slabs and concrete driveways with ease
- Tank drain plug allows fluid emptying into low drains without lifting the full container
- Complete tool kit supplies 7-foot hose, extension wands, utility nozzle, and crevice attachment
Dyno Thermal Bench Telemetry
Line current draws 9.8 Amps on 120 Volt service under loaded suction through a restricted floor shoe. Motor housing temperatures climb 42°F above ambient room levels after 45 minutes of heavy fluid extraction. Exhaust port air discharge stabilizes at 120°F under sustained high-lift operation. Suction loss checks out at 6-inch water lift across the standard 7-foot hose. Noise level testing records 76 dBA at 10 feet under open airflow, reaching 80 dBA under full seal.
Jobsite Bounds Maintenance Rules
The four-caster dolly base swivels across smooth floors, but rolling over rough gravel or extension cords can tip the tall tank. Commercial drywall finishing crews should pass on this unit, as fine gypsum dust blinds the standard cartridge and damages flow-through motor bearings. Sucking hot charcoal embers, flammable fuel spills, or explosive lacquer thinners will spark motor brush arcs and cause canister fires.
- Remove the cartridge filter and install the foam sleeve before any wet extraction task
- Check the drain plug threads once per week for grit accumulation that prevents airtight sealing
- Tap out dry dust cakes from the cartridge filter outside before suction begins to drop
Factory Warranty Package Manifest
Shop-Vac covers this machine with a 5-Year commercial warranty covering motor and tank defects. Unboxing provides the 12 Gallon vacuum unit, four caster dollies, 7-foot hose, two extension wands, floor utility nozzle, crevice tool, cartridge filter, foam sleeve, and filter bag.