Description
Trailing air lines kink around chassis stands and trip assembly mechanics during high-volume truck body manufacturing. The Makita 18V LXT Lithium-Ion Brushless cordless one-quarter-inch rivet tool kit drives structural blind fasteners without dragging air hoses across shops. This eighteen-volt kit delivers twenty kilonewtons of pulling force for rivets up to one-quarter-inch diameter. Neglecting jaw cleaning causes metal shavings to pack between teeth, resulting in mandrel slippage.
The power architecture integrates an industrial brushless motor linked to an all-metal planetary reduction gear train and linear ball screw. Needle roller bearings and heavy-duty thrust rings absorb twenty kilonewtons of axial tensile pull without tolerance loss. The front barrel sleeve is machined from high-tensile ductile alloy steel to survive harsh shop abuse. S7 shock-resistant tool steel jaws grip mandrel shafts firmly to eliminate slippage during tensioning.
Blind Rivet Hardware Architecture
A thirty-millimeter stroke length sets structural blind rivets in a single continuous pulling action without short-stroke re-gripping. High-capacity five-amp-hour batteries provide enough electrical power to set thousands of structural blind rivets per charge.
- Eighteen-volt brushless motor delivers twenty kilonewtons of pulling force to seat blind rivets up to one-quarter inch
- Thirty-millimeter stroke sets structural commercial blind rivets in a single uninterrupted pulling pass
- Dual five-amp-hour lithium-ion batteries provide continuous all-day assembly power through rapid charge cycles
- Transparent mandrel collection container catches spent rivet stems to keep shop assembly floors clean
- Integrated LED work light illuminates fastener hole alignment marks inside dark vehicle cargo interiors
- Compact nosepiece assembly allows riveting clearance inside narrow sheet metal channels and corners
- Rubberized grip handle dampens mechanical snap-back recoil when rivet mandrels break under tension
Tensile Pull Bench Telemetry
Testing registers peak pulling force output of 4,500 pounds (20 kN) across a full 1.18-inch (30 mm) stroke. Baseline pneumatic blind riveter comparison matches an air consumption rate of 7.5 CFM at 90 PSI dynamic through three-eighths-inch lines. Noise meter testing captures 79 dBA at operator ear level upon mandrel snap. Drive housing temperatures rise twenty-two degrees Fahrenheit above ambient across two hundred continuous rivet cycles. Mechanical cycle speed completes full rivet setting and mandrel ejection in 1.6 seconds.
Fleet Service Practical Directives
Never attempt to pull specialized Huck lockbolts or threaded rivet nuts with this blind rivet puller. Forcing threaded fasteners into the smooth jaw carriage strips internal teeth and overloads motor drive circuits. Operating with a jammed mandrel tube forces spent stems back into the gearcase, causing catastrophic mechanical gear failure.
- Clean metal shavings and grit from the three-piece jaw set using mineral spirits and a stiff wire brush.
- Coat the angled exterior of the jaw case with synthetic bearing grease to maintain smooth jaw expansion.
- Empty the clear plastic mandrel collection container before spent stems back up into the nose housing.
Warranty Terms Kit Inventory
Makita covers this cordless rivet tool with a 3-Year limited warranty covering electrical components, motor, and gear mechanisms. The complete kit package includes one XVR02 rivet tool, two 18V LXT 5.0Ah batteries, one rapid charger, four nosepiece sizes, jaw set, tool case, and manual.
