Description
Air line moisture freezing inside pneumatic rivet guns halts production line assembly inside unheated fabrication shops. The Makita 18V LXT Lithium-Ion Brushless cordless one-quarter-inch rivet tool bare tool installs heavy commercial rivets without air hoses. This eighteen-volt tool delivers twenty kilonewtons of pulling force for fasteners up to one-quarter-inch diameter. Worn jaw teeth slip on hardened stainless steel mandrels, causing incomplete fastener compression.
An internal brushless motor wet-end powers an all-metal planetary reduction gear set paired with a case-hardened linear ball screw. Precision needle roller bearings and heavy-duty axial thrust rings absorb twenty kilonewtons of pulling tension without tolerance loss. The front barrel casting is machined from ductile alloy steel to survive industrial drop shock. S7 shock-resistant tool steel jaws grip mandrel shafts firmly to eliminate slippage during tensioning.
Blind Fastener Hardware Matrix
A thirty-millimeter stroke length sets structural blind rivets in a single continuous pulling action without short-stroke re-gripping. The bare tool chassis pairs with existing eighteen-volt LXT batteries to lower fleet equipment acquisition costs.
- Eighteen-volt brushless motor delivers twenty kilonewtons of pulling force to seat structural blind rivets up to one-quarter inch
- Thirty-millimeter stroke sets long-grip commercial fasteners in a single uninterrupted pulling pass
- Transparent mandrel collection container catches spent rivet stems to keep shop assembly floors clean
- Built-in LED work light illuminates fastener hole alignment marks inside dark vehicle chassis recesses
- Compact nosepiece profile permits fastener installation inside narrow sheet metal channels and frame corners
- Rubberized grip handle dampens mechanical snap-back recoil when rivet mandrels break under tension
- On-tool nosepiece storage holds alternative nosepiece sizes and maintenance wrench for fast changeovers
Tensile Pull Bench Telemetry
Testing registers peak pulling force output of 4,500 pounds (20 kN) across a full 1.18-inch (30 mm) stroke. Baseline pneumatic blind riveter comparison matches an air consumption rate of 7.5 CFM at 90 PSI dynamic through three-eighths-inch lines. Noise meter testing captures 79 dBA at operator ear level upon mandrel snap. Drive housing temperatures rise twenty-two degrees Fahrenheit above ambient across two hundred continuous rivet cycles. Mechanical cycle speed completes full rivet setting and mandrel ejection in 1.6 seconds.
Fleet Service Practical Directives
Never attempt to pull specialized Huck lockbolts or threaded rivet nuts with this blind rivet puller. Forcing threaded fasteners into the smooth jaw carriage strips internal teeth and overloads motor drive circuits. Operating with a jammed mandrel tube forces spent stems back into the gearcase, causing catastrophic mechanical gear failure.
- Clean metal shavings and grit from the three-piece jaw set using mineral spirits and a stiff wire brush.
- Coat the angled exterior of the jaw case with synthetic bearing grease to maintain smooth jaw expansion.
- Empty the clear plastic mandrel collection container before spent stems back up into the nose housing.
Warranty Statement Bare Tool Checklist
Makita covers this professional rivet tool with a 3-Year limited warranty against defects in materials and internal workmanship. The bare tool shipment contains one XVR02Z cordless rivet tool, four interchangeable nosepiece tips, jaw pusher assemblies, accessory wrench, and an illustrated technical instruction booklet.
