Description
Blizzard operations grind to a halt when damp sand packs down and stalls light-duty auger flights. The Buyers Products Company SaltDogg PRO3000CH 3.0 Cubic Yard Electric Poly Hopper Spreader – Conveyor Chain drags heavy abrasive sand mixes through an extra-wide pintle chain bed. It carries 3.0 Cubic Yards of deicing media. High electrical current draws demand a heavy-duty truck charging alternator.
A seamless double-wall polyethylene hopper absorbs severe loader bucket impacts without cracking while eliminating rust across decades of service. The conveyor bed utilizes a heavy pintle chain with forged cross bars sliding over a replaceable 304 stainless steel floor plate. Dual 12 Volt DC high-torque motors drive the chain conveyor and spinner disc through sealed reduction gearboxes.
Electric Pintle Chain Deicing Architecture
Separate electric motor controls allow drivers to run the chain conveyor fast for heavy sand drops while holding a tight spinner broadcast. The hopper mounts onto heavy commercial flatbeds or dump truck chassis.
- 3.0 Cubic Yard poly hopper carries up to 6000 pounds of bulk rock salt, coarse sand, and chemical mixtures.
- High-torque 3/4 Horsepower conveyor gear motor drags the heavy pintle chain through packed material beds.
- Independent 1/2 Horsepower spinner motor spreads deicing chemicals from 5 to 30 feet wide across streets.
- High-strength pintle chain conveyor pulls dense sand without slipping or losing positive mechanical drive.
- 14-inch heavy polymer spinner disc resists chemical rust and stands up to flying gravel strikes.
- In-cab digital dual-variable controller provides independent dial adjustment of material feed and spread width.
- Top steel screening grids filter out massive gravel chunks and frozen crusts during loader filling.
Motor Amperage Draw Thermal Profiles
Under a full 6000-pound load of wet abrasive sand, the conveyor motor draws 56 Amps at 12 Volts DC under heavy resistance. The spinner motor draws 24 Amps at 700 RPM. Conveyor gearbox surface temperature stabilizes at 144°F after two hours of continuous parking lot deicing. In-cab controller heat rises 12°F above cabin ambient.
Fleet Winter Bounds Preventative Protocols
Commercial snow contractors, municipal street crews, and industrial plant managers spread dense abrasive mixtures with this chain platform. Do not install this 3.0 Cubic Yard unit on single-axle light trucks because loaded gross weights exceed factory axle ratings. Never allow wet sand and salt mixtures to sit inside the hopper during warm summer months.
- Check pintle chain tension every 30 days and adjust tensioner bolts to maintain proper bottom sag.
- Coat the steel pintle chain links with rust inhibitor oil at the end of each winter season.
- Inspect high-current 12 Volt electrical harness connections for corrosion and apply dielectric silicone.
Factory Guarantee Spreader Inventory Manifest
Buyers Products Company protects the PRO3000CH with a 1-Year commercial warranty covering poly hopper integrity, drive motors, and electrical controls. The shipment arrives with the 3.0 Cubic Yard poly hopper, pintle chain drive, spinner chute, in-cab dual controller, wire harnesses, and top screens.