Description
Jobsite wire pulling stops dead when loose spools tangle, tip over, and bind against framing studs during pulls. The Southwire SIMpull CoilPAK Utility Cart transports and dispenses heavy wire payoff packages across commercial jobsites without spool jacks. It carries multiple wire packs with an integrated payload frame. Small transport wheels struggle over deep exterior jobsite mud.
Heavy-duty tubular steel tubing forms the welded cart chassis to resist racking forces when loaded with several hundred pounds of copper conductor. An industrial powder coat finish protects the steel frame against jobsite moisture and chemical corrosion. Solid polyurethane tires roll on steel rim hubs with integrated sealed ball bearings to resist abrasive concrete dust penetration.
Jobsite Wire Dispensing Mobility Framework
Dual payoff positions let commercial electricians pull multiple branch circuit conductors straight out of factory packaging simultaneously. The compact transport geometry navigates through standard commercial doorways and tight electrical closet openings.
- Multi-pack cargo capacity holds up to four SIMpull CoilPAK wire dispensers securely in place.
- All-welded tubular steel frame supports heavy electrical cable loads across commercial concrete decks.
- Solid rubber flat-free tires roll over jobsite screws, metal studs, and sharp framing debris.
- Integrated payoff wire guides prevent conductor insulation from catching on metal cart framework.
- Sturdy stair glides on the rear frame uprights simplify moving loaded carts up exterior steps.
- Narrow frame width fits through standard 32-inch commercial office building passage doors.
- Dual front stabilizing feet lock the cart stationary during high-tension manual cable pulls.
Transport Load Torsion Bench Tests
Loading the cart with 240 pounds of CoilPAK cable packages results in a low rolling resistance pulling force of only 14 pounds on smooth concrete surfaces. Frame deflection measures less than 0.040 inches under full static weight loading. Conductor pull-off tension through the integrated wire guides requires only 4.5 pounds of pull force at 60 feet per minute feed speed. Acoustic rolling noise measures 62 dBA over broom-finished industrial floors.
Jobsite Utility Scope Handling Mandates
Commercial electrical contractors wiring branch circuits in high-rise buildings and healthcare facilities gain clean cable dispensing with this cart. Do not buy this cart to transport oversized master reels exceeding 100 pounds each because it only accommodates specific CoilPAK containers. Never pull the cart behind motorized vehicles or utility equipment across rough outdoor terrain.
- Wipe down the polyurethane guide rings monthly to remove pulled copper wire insulation shavings.
- Grease the solid wheel axle bearings every six months using standard marine waterproof grease.
- Tighten all frame assembly hardware every 90 days to prevent loosening from jobsite vibration.
- Store the cart indoors during freezing winter weather to prevent moisture freeze damage in tube joints.
Manufacturer Terms Delivery Inventory
Southwire provides a 1-Year commercial manufacturer warranty against structural tube weld cracks and wheel axle failures. The unboxed unit contains the welded steel utility cart frame, two flat-free rubber wheel assemblies, axle mounting hardware, integrated payoff guide brackets, and assembly instructions.
