Description
Electricians waste valuable labor hours moving individual small wire boxes around rough concrete commercial jobsites. The Southwire SIMpull CoilPAK Cart transports, protects, and dispenses multiple branch circuit wire packaging units simultaneously across active commercial builds. It accommodates four CoilPAK containers in a compact hand truck layout. Pushing a fully loaded cart up steep trailer ramps strains single operators.
The cart frame is built from heavy-gauge tubular steel with welded cross-braces that resist torsional twisting under off-center dynamic loads. Solid flat-free tires mount to a solid 5/8-inch cold-rolled steel axle to eliminate tire flats caused by framing nails and tie wire. Durable powder coat paint protects the entire tubular assembly against exterior jobsite rust and abrasion.
Integrated Wire Payoff Branch Circuit Setup
A central payoff guide system lets electricians pull up to four conductors directly from the cart without moving individual boxes. The balanced center of gravity keeps the cart upright during rapid, hand-pulled wire runs down commercial hallways.
- Four-compartment storage rack holds up to four Southwire SIMpull CoilPAK containers firmly in place.
- Solid polyurethane flat-free tires resist punctures from sheet metal screws and jobsite metal shavings.
- Tubular steel transport frame handles up to 240 pounds of total wire payload across rough decks.
- Individual wire guide eyes route branch circuit conductors cleanly to prevent insulation snags.
- Integrated rear tilt bars help operators tip loaded carts back onto transport wheels with low effort.
- Narrow frame design slips through commercial interior doorways and standard drywall stud openings.
- Wide front contact feet stabilize the cart on concrete decks during high-tension manual wire pulls.
Payload Rolling Resistance Towing Telemetry
Testing with a full payload of 220 pounds across broom-finished concrete floors reveals a rolling start pull force of 12 pounds. Wire pull tension through all four polymer guide rings measures only 2.2 pounds per conductor at a steady payout rate of 50 feet per minute. Frame deflection under maximum static load registers below 0.025 inches across the bottom tray. Rolling sound levels measure 60 dBA on concrete surfaces.
Jobsite Application Scope Fleet Maintenance
Multi-story commercial electrical contractors and data infrastructure installers will maximize pulling efficiency using this transport cart. Do not purchase this cart for holding traditional wooden or plastic cable spools because the frame pockets exclusively fit CoilPAK containers. Never overload the cart past its 250-pound maximum weight limit by stacking loose electrical fittings on top.
- Inspect the polymer wire guide rings monthly for deep groove wear that could snag thin wire insulation.
- Clean sheetrock dust and debris from the wheel axles every 30 days to protect the sealed wheel bearings.
- Check all frame assembly bolts and wheel axle lock nuts every three months for proper tightness.
- Wipe down the powder-coated steel tubes with protective oil if stored inside open jobsite shipping containers.
Factory Guarantee Equipment Manifest
Southwire covers this SIMpull CoilPAK cart with a 1-Year commercial warranty covering structural frame weld integrity and wheel hardware defects. The product arrives packaged with the welded tubular cart frame, two flat-free tire assemblies, solid steel axle, axle retaining pins, integrated wire guides, and setup hardware.
