Description
Drain residual surface floodwater off flat roofs, parking garages, and flooded basement slabs. The Tsurumi LSC1.4S Electric Submersible Pump unit clears liquid puddles down to 0.04-inch depths. A 0.5-horsepower electric motor turns an abrasive-resistant urethane rubber impeller. The bottom suction plate cannot pass solid gravel particles exceeding 0.08-inch diameter.
Solid aluminum alloy forms the motor casing, protected by a resilient synthetic rubber outer casing. A semi-vortex urethane impeller resists abrasive scoring from concrete grit. Dual silicon carbide mechanical seals run inside an oil lifter chamber to survive dry running. An internal non-return check valve stops discharged water from back-flowing onto cleaned floors when shut down. Top-discharge geometry cools motor windings.
Low Residue Submersible Specs
Restoration technicians clear shallow standing water without leaving deep puddles on concrete slabs. The internal oil lifter protects mechanical seals even if the pump runs dry.
- Continuous-duty 0.5-horsepower motor operates on standard single-phase 115-volt utility power
- Semi-vortex urethane impeller delivers 45 GPM while draining water down to 1 millimeter
- Built-in check valve prevents pumped discharge water from surging back onto dry floors
- Internal oil lifter lubricates mechanical seals during shallow low-water conditions
- Silicon carbide mechanical faces resist abrasive wear from suspended silica sand
- Heavy 32-foot rubber power cord includes strain relief to prevent electrical shorts
- Standard 0.75-inch garden hose discharge adapter allows fast connection to drain lines
Motor Stress Bench Telemetry
Dynamometer testing confirms the motor draws 5.4 Amps across 115-volt lines under a 15-foot dynamic discharge head. Pump output stabilizes at 32 GPM through 50 feet of 1.25-inch hose. Stator temperature reaches 142°F during extended dry residue priming. Acoustic telemetry records 56 dBA submerged and 63 dBA in open air.
Jobsite Operation Mechanical Realities
You place this flat pump straight onto wet concrete floors using the top carry handle. The weighted base plate prevents the unit from floating in surging water. Do not pick up or move this machine by the rubber power cable. Yanking the electrical cord pulls wires from internal terminals and causes electrical shocks.
- Inspect the rubber suction cushion plate for trapped leaves before placing on floors
- Check seal chamber lubricating oil clarity through the inspection port once a year
- Rinse the pump volute with fresh water after pumping acidic water or slurry
Factory Warranty Complete Manifest
Tsurumi covers this residue dewatering pump with a 2-Year limited warranty against manufacturing defects. The factory crate contains the residue pump, 32-foot power cable, multi-size discharge adapter, check valve plate, and comprehensive operational guide.
