Description
Jagged plastic pipe burrs ruin gasket seals on large diameter municipal PVC water mains. The Reed Mfg Bevel Boss Pipe Beveler with Milwaukee 2984-20 Die Grinder and 12Deg Carbide Router Bit creates factory-grade pipe bevels on plastic mains. Operating through a high-torque rotary drive head, this unit cuts consistent 12-degree bevel angles rapidly. Forcing the router bit into pipe walls without proper guide shoe contact causes severe bit chatter and broken carbide flutes.
An all-metal guide collar assembly mounts directly to a cordless industrial die grinder spindle to control router depth. The solid tungsten carbide router bit features precision-ground 12-degree cutting flutes designed for smooth chip evacuation across heavy plastic pipe walls. An adjustable depth plate indexes along pipe exteriors to ensure uniform bevel width around irregular pipe circumferences. Sealed ball bearings inside the guide carriage isolate rotational side loads from the drive spindle. Road grit and abrasive pipe dust degrade guide rollers unless cleaned after utility trench operations.
Pipe Beveling Hardware Array Specifications
Municipal utility installation requires exact pipe beveling to seat rubber push-on pipe gaskets without gasket roll-out. The specialized guide fixture pairs high-speed rotary cutting with exact angular alignment.
- Cordless electric die grinder drive provides high rotational torque without trailing pneumatic air hoses
- Solid tungsten carbide router bit cuts clean 12-degree bevel angles across C900 PVC pipe ends
- Adjustable guide shoe maintains consistent cutting depth around out-of-round plastic pipe walls
- Heavy-duty aluminum guide frame withstands jobsite trench falls and abrasive aggregate grit
- Precision collet clamp locks the router bit securely to eliminate rotational runout under heavy cuts
- Integrated chip deflector channels plastic shavings away from operator eyes and gasket surfaces
- Tool-free guide adjustment knobs allow fast adjustments across pipe sizes from two to twelve inches
Rotary Cutting Bench Telemetry Analysis
The cordless electric drive motor draws power through high-capacity lithium battery cells under heavy plastic cutting loads. Free speed spins up to 20,000 RPM, slowing down to 16,500 RPM under aggressive operator feed pressure. The 12-degree carbide bit removes a full bevel around an 8-inch C900 PVC pipe in under thirty seconds. Continuous plastic shaving generation creates frictional heat that warms the router bit head to 130°F. Rotational torque output measures 3.2 ft-lbs at peak cutting resistance. Acoustic sound pressure levels measure 86 dBA.
Trench Utility Directives Application Limits
Trench pipe preparation demands disciplined tool tracking to prevent gasket joint failure. Structural metal fabricators should not purchase this plastic pipe beveler because the carbide flutes dull instantly against steel pipe. Running the router bit without the guide collar pressed firmly against the pipe face will gouge the plastic gasket sealing surface.
- Brush fine plastic shavings and trench grit away from the guide roller bearings after every pipe cut
- Inspect the tungsten carbide router bit cutting flutes for chipped edges before beveling plastic pipe
- Check guide shoe thumb-screws for tightness to maintain true 12-degree bevel profile geometry
Commercial Warranty Terms Complete Box Contents
Reed Mfg backs this pipe beveling system with a 1-Year commercial warranty covering manufacturing and material defects. The complete packaged kit contains the Bevel Boss fixture, the Milwaukee 2984-20 die grinder, a 12-degree carbide router bit, service wrenches, and the operator instruction manual.