Description
Manual lever shears butcher large copper feeder cables and produce mashed conductor ends that reject compression terminals. The Milwaukee M18 FORCE LOGIC Cable Cutter Kit with 750 MCM copper jaws slices feeder conductors without strand distortion. An enclosed hydraulic ram delivers six tons of cutting thrust in three seconds flat. Steel-reinforced cable profiles will chip these pure copper jaw cutting edges.
Forged alloy tool steel jaw sets feature CNC-ground blade profiles that grip, slice, and hold round wire geometry. The internal hydraulic powerhead integrates a brushless motor, high-pressure pump block, and specialized solenoid release valve. Planetary reduction gears feed torque into the mini-piston pump with minimal mechanical friction. Sealed electronics resist copper strand dust, moisture droplets, and dirt contamination typical of utility vaults.
FORCE LOGIC Cutter Kit Specifications
Balanced inline architecture permits one-handed tool alignment inside crowded panel enclosures. Rapid jaw closure cuts round conductor cross sections without flattening copper strand clusters.
- 750 MCM copper capacity shears heavy commercial feeder conductors with square cut finishes
- 6-ton hydraulic thrust ram cleanly slices dense copper wire without strand deformation
- 350-degree rotating head orientation navigates tight electrical distribution switchgear panels
- Brushless motor wet-end resists brush friction wear and delivers maximum battery run time
- Automatic jaw open cycle retracts cutter blades immediately upon clean cable severance
- Quick-change jaw pin mechanism swaps cutter heads for alternative wire applications
- Sealed electrical circuitry blocks moisture, airborne copper swarf, and jobsite dust
Hydraulic Dyno Load Data
Dyno bench meters record electric current and fluid pressure throughout 750 MCM copper cuts. The motor draws 2.4 amperes running free, spiking to 21 amperes during final central core wire severance. Hydraulic pressure builds smoothly from 1200 PSI to a peak of 8100 PSI over a 3.1-second stroke. Sound output measures 74 dBA at one meter. Tool motor surface temperatures climb 12 degrees Fahrenheit across twenty consecutive conductor shears.
Field Service Operational Traps
Blade misalignments happen when operators try to shear loose steel bolts or ACSR cables. Demolition teams clearing mixed steel and aluminum conduit lines must look elsewhere. Never operate this cutter without fully seating the jaw locking pin.
- Clean copper dust out of jaw tracks using dry shop air every morning.
- Lubricate blade pivot pins with ISO VG 32 machine oil every hundred cycles.
- Verify jaw alignment tolerances with feeler gauges after clearing conductor jams.
Commercial Warranty Package Inventory
Milwaukee covers this cable cutter kit with a 5-Year commercial warranty on tool and hydraulic mechanisms. The kit carton includes the cable cutter base unit, 750 MCM copper cutting jaw, M18 2.0Ah battery, multi-voltage charger, wrist lanyard, and hard case.
