Description
Spark spray hazards and scorched tubing ends foul clean shop air when sectioning small structural bars with dry friction chops. The JET 5 x 8 Horizontal J-3230 wet bandsaw delivers square cold cuts using a 1/2 HP motor and integrated flood coolant pump. The lightweight stamped steel legs can twist under heavy structural steel channel, demanding floor anchor bolts on uneven shop decks.
A rigid cast iron saw head pivots on heavy ground trunnion pins, damping tooth harmonics through thick steel pipe walls. The 1/2 HP motor drives a three-speed step pulley and an industrial worm gear reducer running in a sealed oil bath to drop motor speed to cold cutting velocities. Ball bearing blade guides hold the flexible bi-metal band tracking perpendicular, while an electric submersible pump delivers coolant directly into the cut kerf.
Wet Horizontal Metal Cutting Hardware Parameters
Maintenance shops require clean square cuts on carbon steel bar and pipe without generating hazardous airborne abrasive dust. Integrated coolant systems wash chips away from tooth gullets to prevent premature band dulling.
- 0.5 HP motor operates on standard 115-volt circuits to supply dependable metal sectioning power
- Three blade speeds of 85, 125, and 200 feet per minute match carbon steel, brass, and aluminum shapes
- 5-inch round and 5×8-inch rectangular cutting capacity clears standard pipes and structural unistrut
- Built-in flood coolant pump washes metal swarf away from the blade to extend bi-metal tooth sharpness
- Hydraulic feed cylinder regulates downward head descent to protect delicate teeth on sharp structural corners
- Heavy cast iron vise swivels forty-five degrees to execute accurate miter cuts on structural tubing
- Automatic shutoff limit switch cuts motor power the instant the blade finishes the bottom cut
Bench Load Telemetry Amperage Draw
The motor pulls 4.2 amps at idle on standard 115-volt utility feeds. Sectioning three-inch solid cold-rolled steel bar at 125 feet per minute brings continuous current draw to 7.6 amps while band velocity remains steady. Hydraulic downfeed valves hold head drop rates within four thousandths of an inch per second. Operating sound levels hold at 70 dBA, allowing continuous fabrication without noise fatigue.
Field Service Trade-Offs Application Filter
Do not use this saw for slicing thin sheet metal panels or wood planks. Inexperienced welders who push down on the saw head without opening the hydraulic cylinder strip band teeth on solid bar stock. Empty metal swarf out of the coolant pump basin at the end of each shift. Check gearbox oil levels through the sight plug every two hundred operating hours. Verify blade tracking centered on the cast wheels before tensioning new bands.
Warranty Protection Standard Package Items
A 2-Year limited warranty covers mechanical drive components, casting integrity, and electrical motor switches. The delivery package contains the horizontal wet bandsaw, steel leg stand, bi-metal bandsaw blade, flood coolant pump system, material stop rod, and assembly tools.
