Description
Pneumatic rivet gun airlines snag on shop equipment and drop line pressure during high-speed trailer skin riveting. The Makita 18V LXT Lithium-Ion Brushless cordless rivet tool kit drives blind rivets without trailing hoses or loud compressor cycling. This eighteen-volt kit pulls rivets up to three-sixteenths-inch diameter in aluminum, steel, and stainless steel. Using worn jaw sets causes incomplete mandrel shearing and annoying fastener jams.
The power architecture utilizes an industrial brushless motor linked to an all-metal planetary reduction gear train and linear ball screw. Needle roller bearings and heavy-duty thrust rings absorb ten kilonewtons of axial tensile pull without tolerance loss. The front barrel sleeve is machined from high-tensile ductile alloy steel to survive industrial assembly shop abuse. S7 shock-resistant tool steel jaws grip mandrel shafts firmly to eliminate slippage during tensioning.
Blind Rivet Hardware Architecture
A long twenty-five-millimeter stroke length sets structural blind rivets in a single continuous pulling action without short-stroke re-gripping. High-capacity five-amp-hour batteries provide enough electrical power to set thousands of blind rivets per charge.
- Eighteen-volt brushless motor delivers ten kilonewtons of pulling force to seat blind rivets up to three-sixteenths inch
- Twenty-five-millimeter stroke sets most commercial blind rivets in a single uninterrupted pulling pass
- Dual five-amp-hour lithium-ion batteries provide continuous all-day assembly power through rapid charge cycles
- Transparent mandrel collection container catches spent rivet stems to keep shop assembly floors clean
- Integrated LED work light illuminates fastener hole alignment marks inside dark vehicle cargo interiors
- Compact nosepiece assembly allows riveting clearance inside narrow sheet metal channels and corners
- Rubberized grip handle dampens mechanical snap-back recoil when rivet mandrels break under tension
Tensile Pull Bench Telemetry
Testing registers peak pulling force output of 2,248 pounds (10 kN) across a full 0.98-inch (25 mm) stroke. Baseline pneumatic blind riveter comparison matches an air consumption rate of 4.2 CFM at 90 PSI dynamic through three-eighths-inch lines. Noise meter testing captures 75 dBA at operator ear level upon mandrel snap. Drive housing temperatures rise eighteen degrees Fahrenheit above ambient across two hundred continuous rivet cycles. Mechanical cycle speed completes full rivet setting and mandrel ejection in 1.4 seconds.
Fleet Service Practical Directives
Never attempt to pull one-quarter-inch structural monobolt rivets or heavy steel lockbolts with this three-sixteenths-inch rated tool. Forcing oversized structural pins into the nosepiece jams the jaw carriage and overloads internal motor drive circuits. Operating with a jammed mandrel tube forces spent stems back into the gearcase, causing mechanical gear failure.
- Clean aluminum shavings and grit from the three-piece jaw set using mineral spirits and a stiff wire brush.
- Coat the angled exterior of the jaw case with synthetic bearing grease to maintain smooth jaw expansion.
- Empty the clear plastic mandrel collection container before spent stems back up into the nose housing.
Warranty Terms Kit Inventory
Makita covers this cordless rivet tool with a 3-Year limited warranty covering electrical components, motor, and gear mechanisms. The complete kit package includes one XVR01 rivet tool, two 18V LXT 5.0Ah batteries, one rapid charger, four nosepiece sizes, jaw set, tool case, and manual.
