Description
Wobbly saw stands and imprecise miter detents cause mismatched joints on long architectural crown molding runs. The DEWALT 12 Inch 15 Amp Dual Bevel Compound Miter Saw bundle pairs a double-bevel saw with a lightweight folding stand. This 15-amp compound saw requires substantial shop footprint and cannot transport inside compact car trunks without stand disassembly.
A precision-machined cast aluminum base features a stainless steel miter detent plate with fourteen positive stops to ensure angle repeatability. The high-torque 15-amp motor turns the 12-inch blade at 4000 RPM through hardened steel gears without drive belt slippage. The bundled DWX724 compact stand utilizes tubular aluminum construction capable of supporting up to 500 pounds with extendable material support arms.
Dual Bevel Miter Matrix
Double bevel capability tilts forty-eight degrees left and right with high-visibility cast angle scales for compound cuts. Tall sliding fences support vertical baseboard trim up to 6-1/2 inches against the rear table.
- 15-ampere commercial motor delivers 4000 RPM blade speed for smooth crosscuts in hardwoods
- 12-inch carbide blade cuts 2×8 dimensional lumber at ninety degrees and 2×6 at forty-five
- Dual bevel design tilts forty-eight degrees left and right with positive stops at common angles
- Stainless steel detent plate features fourteen positive stops for fast miter angle repeatability
- Tall sliding fences support vertical baseboards up to 6-1/2 inches and nested crown up to 6-5/8 inches
- DWX724 compact stand features folding legs and extendable arms supporting ten feet of lumber
- Direct dust collection chute captures wood chips into the included fabric collection bag
Shop Load Dyno Telemetry
Dynamometer testing on a 120-volt 20-amp line records 14.5 amperes continuous current draw while cutting 4×4 treated posts. Arbor rotational speed settles at 3780 RPM from a 4010 RPM free-spin baseline under manual feed. Arbor runout measures less than 0.0011 inches total indicator reading. Motor housing temperature rises 33 degrees Fahrenheit after twenty-five continuous compound cuts. Acoustic sound level registers 91 dBA at operator ear level.
Operational Boundaries Field Service
This compound miter saw and stand bundle requires careful setup to avoid deflecting the extended aluminum support arms under heavy lumber. Finish carpenters should not yank the cutting head downward aggressively to avoid deflecting the cast pivot arm. Avoid using light 16-gauge extension cords because voltage drop will burn out motor switch contacts.
- Wipe fence sliding surfaces with dry shop rags daily to remove pitch and abrasive dust.
- Inspect carbon motor brushes every one hundred operating hours and replace if worn down.
- Verify miter fence straightness using a precision metal straightedge after transporting the saw.
- Check stand mounting bracket clamp tension and tighten locking levers to prevent saw shifting.
- Blow fine sawdust out of the lower blade guard pivot spring using shop compressed air weekly.
Warranty Parameters Tool Inventory
DEWALT covers this miter saw and stand bundle with a 3-Year limited warranty including one year of free service. The package includes the 12-inch dual bevel compound miter saw, DWX724 compact miter stand, 12-inch carbide blade, blade wrench, vertical material clamp, dust bag, and instruction manual.
